Roots vacuum pump installation steps

Prepare new parts: Before installing a new roots vacuum pump, make sure all parts are clean and ready.

Mounting the bearing and impeller: Install the internal parts such as the bearing and impeller in sequence according to the position and orientation marked at the time of disassembly. Be careful not to install it backwards or omitted it.

Install the pump cover: Align the pump cover with the groove on the pump body, gently lower and tighten the bolts on the pump cover evenly. Be careful not to be too tight or too loose so as not to affect the sealing effect.

Connect the power supply: Plug in the power plug, start the roots vacuum pump, and check if it is working properly. If there is any problem, please troubleshoot it in time.

The disassembly and installation of roots vacuum pumps is a meticulous and complex process that requires patience and expertise. At the same time, it also reminds everyone to pay attention to maintenance in daily use, regularly check and replace wearing parts, so as to ensure the stable and reliable operation of roots vacuum pumps.